Made By Mueller. Basic mouthguard with a helmet-strap that is made out of fast-fitting Co-Polymer material and fits all sizes. Thin front wall construction does not interfere with speech or breathing. Low profile helps to reduce gagging. Mouthguard Fitting Instructions Fill saucepan with 3 to 4 inches of water. Bring water to a boil. Remove water from heat source. Immediately place mouthguard in water for 90 seconds. Do not remove before 90 seconds. Carefully remove mouthguard from hot water with a slotted spoon. Cool mouthguard under tap water for 1-2 seconds only to bring surface temperature to a comfortable level. Lick your lips before placing mouthguard in your mouth. Watching in mirror, line up mouthguard carefully with the centerline of upper teeth. Fit mouthguard onto and around upper teeth (tongue tag upward) and press firmly into molars first then front teeth. Bring lower jaw forward and up into base of mouthguard with teeth in alignment with lower channel. Close mouth while biting down hard on mouthguard. Suck in strongly and use fingers to press edges of mouthguard onto teeth and roof of mouth through lips and cheeks for 20 seconds. Remove mouthguard and cool under tap water for 30 seconds. Replace into mouth and test for a good, firm fit. Repeat steps 1 through 10 if fit is not accurate.
No review found